---

Building a wood fence can be a fun and rewarding project. In addition to providing value to your home it increases your security and privacy. You'll find it's not a difficult job and I will show you the easy method of building your fence.

Materials Needed:

Treatment preservative
Concrete
4x4 posts 8 feet in length.
2x4 for railing in either 8 or 16 feet in length
1x6 or 1x8 fence boards (your preference)
3 1/2" galvanized nails
2 1/2" flat head galvanized nails
Hardware for gate (hinges and latch)

Before you get started you must first figure out your fence line. This will help you calculate the materials needed to build your fence. When determining your fence line the best thing to do is talk to your neighbors. If you're in disagreement you can look for the property survey markers or if all else fails have your property surveyed. It's best to keep the entire fence on your property. Once you know the fence line mark it with a string line. Using stakes hammered into the ground run the line 2 feet past each end of the fence line. Secure the string tightly to the stakes.

Next you need to treat your posts by following the manufacturers recommendations. I would suggest treatment at least 8 inches above ground level. You can also purchase posts that are pre-treated from your lumber store if you wish.

Measure your post holes 8 feet apart. I wouldn't recommend any further apart as through time your fence may sag or lean. Dig the holes about 28 inches deep. Make sure all posts are of equal distance apart. It's now time to prepare your concrete for setting the posts. Mix your concrete with 1 part cement, 2 parts sand and 3 parts gravel. Add water and mix to a thick consistency but at the same time wet enough to pour all the way around the posts. Fill each hole 6 inches deep. Now it's time to place the posts in every hole. Use a level to make sure each post is plumb and barely touching the string. Finish filling each hole to about 2 inches below ground level. Double check each post making sure it's plumb.

After the posts have set it's time to add the railings. Make sure to set the bottom rail 8 inches above ground and be careful to have both ends the same height from the ground. Fasten the top rails by measuring from the bottom rail up to the desired position. Finally attach the middle rail central between the bottom and top rails.

Before you nail the boards to the railings you might want to consider staining or painting them first as it is easier than doing this after they've been fastened. If you decide to go this route you should also stain or paint the posts and rails prior to attaching the boards. Using a spacer to maintain equal gaps you can begin nailing the boards to the rails, using 2 of the 2 1/2 inch nails hammered on each rail. Use a level to make sure the boards are vertically plumb.

Now that your fence is up you probably want a gate. First you need to determine the size of the gate. I would recommend a gate no less than 3 feet wide. You should build a frame with the 2x4's overlapping and attach a middle rail for durability and strength. To allow room for the hinges and latch make sure the gate frame is built allowing 1 inch narrower between the gate posts. Next attach the fence boards and finally install the hinges and latch.

That's all there is to it. Now it's time to take a break and enjoy the beautiful fence you've just built.

Related Articles on Tools and Equipment

1. How To Insulate A Floor
   
2. How To Remove Wallpaper
   
3. When is a Wrench Like a Martini?
   
4. The advantage of using TV mounts
   
5. The allure of antique and customized TV stands
   
6. How to find the right TV brackets for your unit
   
7. Ways To Assemble Sheet Metal
   
8. Proper Welding Attire
   
9. Bathing For Older People - Part Ix
   

Latest Articles on Tools and Equipment

1. Bathing For Older People - Part Ix
   Safe and accessible bathing is not solely a concern of the elderly, disabled and those caring for them. It is of utmost importance to all people irrespective of their age, sex and cultural background. Eliminating accidental deaths and injuries is of prime importance in creating a safe bathing environment....
2. Proper Welding Attire
   Welding is a hazardous activity that poses safety and health risks if precautionary measures are not followed. One effective way of preventing accidents when working with welded materials is by wearing the proper welding attire.For safety reasons, all welders must give utmost attention to protecting themselves....
3. Ways To Assemble Sheet Metal
   Working with sheet metal, especially the thin ones, is such a daunting task for amateur and inexperienced builders or welders. Nowadays, there are many different ways for assembling sheet metal, but the principle behind it remains the same. Sheet metal assembly, regardless of its method, refers to the process of fastening or combining two or more metal components to come up with a single output....
4. How to find the right TV brackets for your unit
   If you are looking for TV Brackets, then take a look at our exclusive range on the website - the perfect way to support your LCD and Plasma TV’s. When shopping for TV brackets, one has to keep in mind the make and model of the set you are buying the brackets for. Although most brackets can be fairly universal, some may not be the best items to buy for your particular set, especially if the height ...
5. The allure of antique and customized TV stands
   If you are looking for TV Stands, then take a look at our exclusive range on the website - the perfect way to support your LCD and Plasma TV’s. People on the hunt for unique or quality TV stands may find just what they want with a little effort. The best thing about acquiring an antique is not only the intrinsic value of such a piece, but how it can become a treasured relic among many items that c...
6. The advantage of using TV mounts
   If you are looking for TV Mounts, then take a look at our exclusive range on the website - the perfect way to support your LCD and Plasma TV’s. After buying a plasma or Flat screen TV, a person may be faced with whether or not to place their brand spanking new set on a stand or on TV mounts....
7. When is a Wrench Like a Martini?
   Last week, we were looking at the 2007 IDEA Award winners and we stumbled over this product. The "Revolutionized Wrench" (also known as the X-Beam wrench. This "wrench with a twist" in no way alters the function of basic use of a wrench. Instead, it makes some very simple changes to civilize the classic, straight wrench. Not so long ago, we were looking at the 2007 IDEA Award winners and we stumbl...
8. How To Build A Wood Fence
   Building a wood fence can be a fun and rewarding project. In addition to providing value to your home it increases your security and privacy. You'll find it's not a difficult job and I will show you the easy method of building your fence. ...
9. How To Remove Wallpaper
   Removing wallpaper doesn't have to be a tedious and dreadful project. Yes it will take a little time and some elbow grease but if you follow these steps you will end up with the wallpaper and glue completely removed and then you can move on to painting your walls or hanging new wallpaper....
10. How To Insulate A Floor
    Believe it or not you lose a lot of heat through your floor during the winter months and on the reverse end of things you can gain unwanted heat during the summer months. You can save money each year by insulating your floor. This is a home improvement must that is often overlooked. ...

Related topics in Home and Family

Submit Articles © 2009 KeepArticles.com, All Rights Reserved.